User Manual Example Not Working (?)

02272014, 03:05 PM
(This post was last modified: 02272014 03:06 PM by NMihiylov.)
Post: #1




User Manual Example Not Working (?)
Has anyone tried the example given within Chapter 7 for the Advanced Graphing App?
I am referencing example 3.) mod x = 3 each time I try to enter the calculation I receive a syntax error. I am not that familiar with this equation  so I contacted HP support, they advised to try to run it on the emulator  I did with the same result, make sure that i have the latest firmware update...I do, then they suggested a reset. Before I reset I thought that I would check here to see if anyone else experienced the same result. Again, it is in Chapter 7, page 125 and it is example #3 Any feedback would greatly be appreciated. Thank you, Nick 

02272014, 03:41 PM
Post: #2




RE: User Manual Example Not Working (?)
y mod x = 3
The y got deleted somewhere along the line. I think it was fixed in the last batch of changes made on the manual, but I'm not 100% sure on that. I will check to find out. TW Although I work for the HP calculator group, the views and opinions I post here are my own. 

02272014, 07:30 PM
(This post was last modified: 02272014 07:31 PM by NMihiylov.)
Post: #3




RE: User Manual Example Not Working (?)
Thank You Tim,
I knew the equation was missing something, but it wasn't sure what it was missing. I modified the equation in the Advanced Graphing app and was able to to recreate the graph as depicted on page 126. Thank you for you advice. Best Regards, Nick 

« Next Oldest  Next Newest »

User(s) browsing this thread: 1 Guest(s)