02-27-2014, 03:05 PM
Has anyone tried the example given within Chapter 7 for the Advanced Graphing App?
I am referencing example 3.) mod x = 3 each time I try to enter the calculation I receive a syntax error.
I am not that familiar with this equation - so I contacted HP support, they advised to try to run it on the emulator - I did with the same result, make sure that i have the latest firmware update...I do, then they suggested a reset. Before I reset I thought that I would check here to see if anyone else experienced the same result.
Again, it is in Chapter 7, page 125 and it is example #3
Any feedback would greatly be appreciated.
Thank you,
Nick
I am referencing example 3.) mod x = 3 each time I try to enter the calculation I receive a syntax error.
I am not that familiar with this equation - so I contacted HP support, they advised to try to run it on the emulator - I did with the same result, make sure that i have the latest firmware update...I do, then they suggested a reset. Before I reset I thought that I would check here to see if anyone else experienced the same result.
Again, it is in Chapter 7, page 125 and it is example #3
Any feedback would greatly be appreciated.
Thank you,
Nick