Post Reply 
Hp25c
06-20-2018, 09:02 PM
Post: #1
Hp25c
It lives! It’s working 100% ok.

Thanks to this thread below.

http://www.hpmuseum.org/cgi-sys/cgiwrap/...read=12608

It just needed a little aluminum foil wrapped around the terminal leads.
Im using a shapeways plastic power pack with a copper dual coiled spring

Question, is there a more permanent solution for the terminal leads?

The aluminum foil falls off when the pack is pulled out.

I can solder, but dont want to mess up the 25c terminal leads and do it incorrectly.
Find all posts by this user
Quote this message in a reply
06-21-2018, 07:53 AM
Post: #2
RE: Hp25c
(06-20-2018 09:02 PM)dm123 Wrote:  Question, is there a more permanent solution for the terminal leads?

I think the ideal solution would be to insert new silver rivets in place of the corroded ones. Some time ago I bought a bag full on eBay but unfortunately they are metric size and a tiny bit too small to make good contact. So double check before ordering...
Find all posts by this user
Quote this message in a reply
06-21-2018, 11:39 AM
Post: #3
RE: Hp25c
(06-20-2018 09:02 PM)dm123 Wrote:  Question, is there a more permanent solution for the terminal leads?





Big Grin
SCNR

Greetings,
    Massimo

-+×÷ ↔ left is right and right is wrong
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 2 Guest(s)