Post Reply 
3D printed calculator stand for HP Prime
09-02-2022, 12:05 AM (This post was last modified: 09-02-2022 03:05 AM by calc_freak.)
Post: #1
3D printed calculator stand for HP Prime
These are very well made, rock solid with a very snug and secure fit.

https://www.ebay.com/itm/165655225307


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
09-02-2022, 03:44 AM
Post: #2
RE: 3D printed calculator stand for HP Prime
(1) The bottom is not depicted. What kind of feet does it have?
(2) Does it stay put on a table when the Prime's keys are pressed?
(3) Is it wide enough to hold a Prime in its slip-on cover, or must the user set the cover aside when using the stand?

<0|ΙΈ|0>
-Joe-
Visit this user's website Find all posts by this user
Quote this message in a reply
09-02-2022, 07:33 AM
Post: #3
RE: 3D printed calculator stand for HP Prime
(09-02-2022 03:44 AM)Joe Horn Wrote:  (1) The bottom is not depicted. What kind of feet does it have?
(2) Does it stay put on a table when the Prime's keys are pressed?
(3) Is it wide enough to hold a Prime in its slip-on cover, or must the user set the cover aside when using the stand?

I've added a picture of the bottom that shows the rubber feet, and a close-up of the rails that slot into the sides of the calculator.

The bottom has rubber feet in each corner.

It stays put on a table - no slipping at all, and it's perfectly level.

Since the stand itself slots into the sides of the calculator, the slip-on case must be set aside.


Attached File(s) Thumbnail(s)
       
Find all posts by this user
Quote this message in a reply
09-02-2022, 12:09 PM
Post: #4
RE: 3D printed calculator stand for HP Prime
Looks nice, though $45 (by the time I have it) seems steep for a 3D printed stand.

--Bob Prosperi
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 2 Guest(s)