41CL Self-Update
|
11-19-2017, 09:49 AM
(This post was last modified: 11-19-2017 07:06 PM by Neve.)
Post: #110
|
|||
|
|||
RE: 41CL Self-Update
I opened up the calc (again) and I checked for possible shorts between the CPLD connector and the female 2.5 jack mounted on the 3D port cover. No shorts there.
Just to verify and be sure it’s not reversed, the ground wire on the CPLD side is the one closest to the FPGA connector, right? And it goes to the longest, curved middle tip on the 2.5 side. If this is the case, I have it right. The only thing that could be wrong, from my point of view, would be the reversed TX/RX on the 2.5 female jack. However, Monte said that his method didn’t check for that.... Should I reverse them again? (Although I tried that earlier and it still didn’t work on the Mac) I’m desperate.... Engineer & Senior IT Executive 2x HP41CL, HP41CX, HP48GX, HP50g, 2x82162A Printer, 2x82143A Printer, 2x HP-IL, 2x Card-Readers, PIL-BOX. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)