GRAPH 3D v2.425 (20-FEB-2017)

[kalredrick87]

(09-29-2015 03:13 PM)Han Wrote:  

(09-29-2015 06:20 AM)kalredrick87 Wrote:  Hello,

I am having a hard time getting the application to run on my new HP prime.
When I type in any equation I get a error: invalid object.
I went into the programs tab on my calculator and when I try to exit I get a syntax error on line 3. I don't know if that means anything.
I copied everything from
#pragma mode( separator(., integer(h32) )
line down to the very end of the file. Program tab on my connector then I sent to class. I really don't know how to describe what I did more then this. any help would be appreciated.

Thanks

Did you ensure your firmware is updated? Typing in an equation and getting invalid object means you typed it in incorrectly. The app only "runs" after you hit the plot key. So if you are getting invalid object just from entering an equation, then there is likely some setting affecting the entry of your equation (e.g. using RPN mode and entering in the formula using "algebraic" notation)

Hello Han,
My Software Version is 2015 6 17 (8151)
Hardware version A
CAS Version 1.1.2-11
Operating system V0.037.526
I updated my firmware and I tried plugging equations in the form
V1: =X*Y
This gives me a invalid error
when I graph this
V1: Z= X*Y shows an empty graph.
I am doing something wrong I tried both ways in your description on the front page. I had to change the file type from .hpappprgm to a .hpapp to try th second method in the install instruction where I put the file in the contents of my connectivity kit in my documents. after that didn't work I deleted it then I copied my advanced graphing and then I opened it up and pasted the code into the program tab. I messed something up somewhere and I am trying to find it but I don't know what I am really looking for.

Thank you for your quick reply!