User Manual Example Not Working (?)
|
02-27-2014, 03:05 PM
(This post was last modified: 02-27-2014 03:06 PM by NMihiylov.)
Post: #1
|
|||
|
|||
User Manual Example Not Working (?)
Has anyone tried the example given within Chapter 7 for the Advanced Graphing App?
I am referencing example 3.) mod x = 3 each time I try to enter the calculation I receive a syntax error. I am not that familiar with this equation - so I contacted HP support, they advised to try to run it on the emulator - I did with the same result, make sure that i have the latest firmware update...I do, then they suggested a reset. Before I reset I thought that I would check here to see if anyone else experienced the same result. Again, it is in Chapter 7, page 125 and it is example #3 Any feedback would greatly be appreciated. Thank you, Nick |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
User Manual Example Not Working (?) - NMihiylov - 02-27-2014 03:05 PM
RE: User Manual Example Not Working (?) - Tim Wessman - 02-27-2014, 03:41 PM
RE: User Manual Example Not Working (?) - NMihiylov - 02-27-2014, 07:30 PM
|
User(s) browsing this thread: 1 Guest(s)