Prime G2 crashes with break command
|
09-01-2019, 05:59 PM
Post: #1
|
|||
|
|||
Prime G2 crashes with break command
Hello,
I recently bought a Prime G2 and I'm still playing around with it, looking at the demo programs. Every time I run the Demo_BREAK the calculator crashes. EXPORT Demo_BREAK() BEGIN FOR A FROM 1 TO 10 DO B:= (A+3) MOD 5; IF B==1 THEN BREAK; END; END; END; The crash occurs when the program exits, so if I add a message box, the message box text is displayed and then the calculator crashes. Following advice I have tried memory resets and formatting the C drive in recovery mode with no success. Does this happen to anyone else's G2? Software Version 2.1.14181 (2018 1016) Thanks. Steve |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Prime G2 crashes with break command - sc99cs - 09-01-2019 05:59 PM
RE: Prime G2 crashes with break command - BartDB - 09-02-2019, 10:05 AM
RE: Prime G2 crashes with break command - sc99cs - 09-02-2019, 11:48 AM
RE: Prime G2 crashes with break command - Tim Wessman - 09-02-2019, 12:36 PM
RE: Prime G2 crashes with break command - BartDB - 09-02-2019, 03:41 PM
RE: Prime G2 crashes with break command - sc99cs - 09-02-2019, 04:21 PM
RE: Prime G2 crashes with break command - toml_12953 - 09-02-2019, 04:54 PM
RE: Prime G2 crashes with break command - Tyann - 09-02-2019, 05:10 PM
RE: Prime G2 crashes with break command - sc99cs - 09-02-2019, 05:31 PM
RE: Prime G2 crashes with break command - BartDB - 09-02-2019, 05:33 PM
RE: Prime G2 crashes with break command - sc99cs - 09-02-2019, 05:35 PM
RE: Prime G2 crashes with break command - mbeddo - 10-14-2019, 09:19 PM
|
User(s) browsing this thread: 1 Guest(s)