HP-41CX w/ XF-Module - just curious
|
07-26-2019, 02:46 AM
Post: #16
|
|||
|
|||
RE: HP-41CX w/ XF-Module - just curious
(07-26-2019 01:10 AM)rprosperi Wrote:Robert,(07-25-2019 05:29 PM)Sylvain Cote Wrote: If I remember correctly, in a C/CV, CAT 2 start its scan at page 5 while in a CX CAT 2 start its scan at page 3 but skip page 4.Those CAT-2 results imply XEQ-ing EMROOM should work, since it is in "-CX EXT FNC", which is seen in your results, but when I tested this, it is not found. Did you try to [XEQ] "EMROOM" with the XFM installed in a CX? You are right, I tried it and the plug-in module hide the internal module for both X-F/M and TIME modules. As a test, without any plug-in modules, I have switched to program mode and entered all the CX X-Fncs and CX Time functions. Without the modules I can see the functions name (ex: EMROOM) but when I plug the X-F/M and the TIME modules I see the XROM's instead (ex: XROM 25,53) I wonder if the same behaviour apply to the hardwired printer ROM (page 6, XROM 29,XX) and HP-IL (page 7, XROM 28,XX). So, right now we can assume that the 41OS CX version behave like the 41OS C/CV version for page priority. Also, we can say that the 41OS in general start searching at least from page 6 before looking at the lower pages. The remaining question is does the search start at page 6 or at page 8. I will do a test setup this weekend that will clarify this point and will come back with the result. Sylvain |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)