polynomial calculations over Z/Zp (for prime p)?

12242013, 04:00 AM
Post: #1




polynomial calculations over Z/Zp (for prime p)?
Hi,
Does the Prime have some way to compute with polynomials whose coefficients are in Z/pZ (for prime p)? If so, I'd be grateful for an example. thank you, Jeff 

12242013, 04:09 AM
Post: #2




RE: polynomial calculations over Z/Zp (for prime p)?
You have several ways of implementing \( \mathbb{Z}/\mathbb{Z}_p[x]\). You can use vectors (of coefficients), actual symbolic expressions, or the "poly" type:
Code:
Graph 3D  QPI  SolveSys 

12242013, 07:04 AM
Post: #3




RE: polynomial calculations over Z/Zp (for prime p)?
Hi,
What are the CAS settings for this to work? For example, quo() is documented in the xcas manual (2.25.3), but I cannot get it to work in the HP prime: quo( (x^3+3x)%5,(2x^2+6x5)%5) should output 2x+1 but I get an error. Same if % is replaced by MOD (or mod). In fact, the HP prime example in the Help for MOD is 9 mod 5 results in an error. Maybe my CAS settings are wrong. 

12242013, 11:56 AM
(This post was last modified: 12242013 12:40 PM by Jeff Nye.)
Post: #4




RE: polynomial calculations over Z/Zp (for prime p)?
(12242013 04:09 AM)Han Wrote: These didn't work for me (using the latest firmware). However, last night I stumbled upon the CAS %%(n,p) operator, which seems to be the % operator in xcas. With %% instead of %, example p1 worked fine. Example p2 produces a polynomial with nonmodular coefficients. For example p3, I needed to say poly([ 12 13 20 5 ] %% p). Linear algebra seems to work with integers mod p. The expression [[4,3],[5,1]]%%3 defines a matrix of integers mod 3. 

12242013, 03:39 PM
Post: #5




RE: polynomial calculations over Z/Zp (for prime p)?
Yes, %% does the job. The single % is for percentage in the Prime. Very convoluted notation thou.


12242013, 03:49 PM
Post: #6




RE: polynomial calculations over Z/Zp (for prime p)?
(12242013 11:56 AM)Jeff Nye Wrote:(12242013 04:09 AM)Han Wrote: Thank you for the corrections Graph 3D  QPI  SolveSys 

12242013, 04:10 PM
Post: #7




RE: polynomial calculations over Z/Zp (for prime p)?
I wonder if one has a choice of residue system used. The %% uses the minimal residue system mod n. Is there a way to display results using the common (or least) residue system mod n (that is, {0,1,...,n1})? The negative signs combined with the double %% make the results rather cumbersome to read.


12252013, 07:55 AM
Post: #8




RE: polynomial calculations over Z/Zp (for prime p)?
You can remove the %% by the %% 0 command, then run irem on each coefficient.


« Next Oldest  Next Newest »

User(s) browsing this thread: