Post Reply 
Public Beta Availiable - Win/Mac/Firmware [UPDATED]
11-14-2017, 03:19 PM
Post: #119
RE: Public Beta Availiable - Win/Mac/Firmware [UPDATED]
(11-14-2017 02:36 AM)Eddie W. Shore Wrote:  Anyone else has this problem:

When creating a program through the Program Catalog, the program is created but the calculator resets. Same thing when I try to delete programs.

This happens to only affect C hardware.

Eddie

I have notified calcbeta@hp.com of this
Yes, I reported this quite a while ago but it happens on my HW A as well as my HW C version. I get rid of it by copying all my programs to a PC (NOT backup!) reformatting the storage and copying programs back to the calculator one at a time testing the new command after each until I find the program that causes the error. I then reformat again, copy the programs one at a time omitting the program that caused the error and test again. If I find more programs that cause the error, I go through the whole process again each time omitting the error-causing program. Eventually none of the programs in memory cause a reboot. I then take the omitted program(s) and reenter them by hand into the CK and from there copy them to the calculator. This whole thing is easier than it sounds and is the only sure cure I've found. The problem is a corrupted storage area.

Tom L

French phrases you rarely hear: "trop de beurre" (too much butter)
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Public Beta Availiable - Win/Mac/Firmware [UPDATED] - toml_12953 - 11-14-2017 03:19 PM



User(s) browsing this thread: 1 Guest(s)