How to Update 41-CL

[smp]

(09-21-2017 07:08 PM)mfleming Wrote:  I did notice the instructions in the presentation did not include setting the clock speed. Make sure you have TURBO 50 so that the processor keeps up with the serial data. On rare occasions I've seen transfers fail the first time, but if it continues to do so, drop the baud rate to 2400 and try again.

Yes! That did the trick. Thanks very much, Mark, for pointing this out. With the TURBO 50 command in there, my CL is now in the middle of performing the update.

smp