Poll: Should I bother with this HP 34C?
[Show Results]
Post Reply 
Should I bother? HP-34C in rough shape
05-13-2018, 06:26 AM (This post was last modified: 05-13-2018 06:28 AM by Zaphod.)
Post: #47
RE: Should I bother? HP-34C in rough shape
(05-13-2018 05:19 AM)dm123 Wrote:  Is there a place that sells battery holders that bridge the one side of the pair, like the original holders did, and at the same time allow you to slide out the batteries so that they can be recharged. I’m trying to find out if there is an easy solution to this. I could not find any battery holders like this. This would be the bast solution

Also, another idea I had, is if one could stick a conducting plate on the nonterminal side of the battery compartment of the calculator so that the batteries could be imsertd right into the compartment directly.(with correct polarities ,right directions)

This manufacturer I found does a plethora of battery terminals and plates (they also do cell holders too)


They are stocked by most of the big distributors (Mouser, Digi , RS and Farnell etc).
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: Should I bother? HP-34C in rough shape - Zaphod - 05-13-2018 06:26 AM

User(s) browsing this thread: 1 Guest(s)