Conversion Routine
|
07-08-2016, 01:58 PM
(This post was last modified: 07-08-2016 03:21 PM by SlideRule.)
Post: #10
|
|||
|
|||
RE: Conversion Routine
(07-07-2016 05:20 PM)Dieter Wrote: Anyway – don't you think that the last step of the subroutine... Dieter I think I sent the pointer back to the top to facilitate the primary use of this more than 35-years-ago routine: convert FT-IN to decimal feet for SUMMATION, otherwise, I've long since forgotten the reason & neglected to document same in the source document. Anyway, I greatly enjoy the analysis & perspective of these old utility routines from an era that struggled thru capability & capacity far less than todays' available calculator selection. Thanks for the second look. BEST! SlideRule |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Conversion Routine - SlideRule - 07-02-2016, 02:45 AM
RE: Conversion Routine - Dieter - 07-02-2016, 06:07 AM
RE: Conversion Routine - SlideRule - 07-02-2016, 12:43 PM
RE: Conversion Routine - Dieter - 07-04-2016, 08:22 PM
RE: Conversion Routine - SlideRule - 07-04-2016, 11:31 PM
RE: Conversion Routine - SlideRule - 07-07-2016, 01:13 AM
RE: Conversion Routine - Dieter - 07-07-2016, 05:20 PM
RE: Conversion Routine - Dieter - 07-07-2016, 06:33 PM
RE: Conversion Routine - SlideRule - 07-08-2016, 12:48 AM
RE: Conversion Routine - SlideRule - 07-08-2016 01:58 PM
RE: Conversion Routine - Dieter - 07-08-2016, 06:32 PM
RE: Conversion Routine - SlideRule - 07-08-2016, 07:41 PM
RE: Conversion Routine - SlideRule - 07-11-2016, 02:52 PM
|
User(s) browsing this thread: 1 Guest(s)