Looking for HP-25 programs

[toml_12953]

(05-22-2016 07:53 PM)Dieter Wrote:  

(05-21-2016 04:12 PM)toml_12953 Wrote:  Instructions:
Enter Corridor Width, Press A
Enter Door Passage, Press B
Enter Wall Thickness, Press C
Enter Cabinet Length (max cabinet width will display), Press D
Display angle necessary x<->t

Could you provide an example here?
And is "Press D" supposed to mean "Press E"? There is no label D, but a label E exists.

(05-21-2016 04:12 PM)toml_12953 Wrote:  A test such as x>=t is followed by a two step address to branch to if the test is true.

Are you sure the jump targets (line 027 and 081) are correct? The former points to the "2" of a RCL 02 command, and instead of the latter line 078 (RCL 04) would make more sense. But maybe I'm wrong here.

You're right. It should be E instead of D and the jump is to 81 (RCL 04....) I've updated the original listing. It now matches what I have in the written copy I made. Sorry, folks!

Tom L