Post Reply 
newRPL: [UPDATED April 27-2017] Firmware for testing available for download
04-12-2017, 09:29 PM (This post was last modified: 04-13-2017 08:01 AM by pier4r.)
Post: #610
RE: newRPL: [UPDATED February 21-2017] Firmware for testing available for download
So I'm not sure if I messed around or it is just the 50g. (I used the firmware linked in the first post)

The firmware flashed neatly, like reported here. I was a bit lost due to missing documentation about menus (yes, I read that Claudio either writes documentation or code, hopefully someone can help sooner or later with the docs. Without docs the end user is lost).

So to display the main menu I need to press SYMB, is that wanted?

For storing instead, I need to press "HIST". Is that wanted? I checked this thread back to page 27, but I did not find precise information how the keyboard is mapped. I thought that STO would have been fine, so I wonder why the decision on HIST.

As far as my understanding goes the system should be mostly oriented for RPL programming, but one big limitation , at least for me, would be the missing possibility to connect to the computer via USB. Or at least I did not find out how I can connect to the computer via usb. Using the SD card to load/unload programs and doing tests is possible, but it takes a while.

my home variables were not overwritten by the flash procedure, nor seen by the newRPL.

Wikis are great, Contribute :)
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: newRPL: [UPDATED February 21-2017] Firmware for testing available for download - pier4r - 04-12-2017 09:29 PM



User(s) browsing this thread: 6 Guest(s)