NP-41 Emulator (may be)
|
12-11-2017, 06:01 PM
Post: #292
|
|||
|
|||
RE: NP-41 Emulator (may be)
(12-10-2017 10:33 PM)mwthomasjr Wrote: I received my NP-41. Looks great! Powered up. I am afraid it might be DOA. The key combo of ON + CLR should show MEMORY LOST. I guess you had already tried 1) taking out and putting back your battery and retry. 2) make sure battery is relatively fresh. 3) try the ON-ON key sequence. 3) You should try to press all keys in the key test to make sure they are register different values to confirm the button solder points are good and working. If not, if you are able to, correct the problematic buttons. 4) The fact that you are seeing the version screen and can run the key test indicate this is not likely a hardware problem. It could happened that the firmware is corrupted and lead to a reset (say random machine code leads to some exception). I had it happen before that after trying to load a ROM via serial interface (which writes to the FRAM memory on the fly) and failed, the emulator got confused when trying to do an internal CAT during power-up, leading to failing to enter calculator mode. In this case the thing we could try is to reload the firmware, except that it will require you to either have a TI programmer, or a USB-Serial setup. If you tried the simple tricks and cannot get it resolved, please send it back and I will swap it w/ a replacement unit. I guess I should have done a remove-and-insert battery check routine before shipping these units out. Instead I just did some calculations w/ the units and take their battery out for shipping. Sorry for having disappointed you. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)