WP 34s registers and integer modes

[signals]

(04-02-2015 05:40 PM)Marcus von Cube Wrote:  You can access values in registers stored in the "wrong" format with specialized RCL commands: iRCL treats the register contents as an integer and converts it to decimal if needed. Likewise sRCL treats the register contents as if it was stored in single precision decimal mode. If called from integer mode, the value is dynamically converted. Now guess what dRCL is meant for...

Thanks again. Now that I know what to look for, I found this info on page 159 in the manual. As I said in an earlier thread, it's going to take some time, and some dumb questions, to fully understand this thing. There's just so much material in the manual.

The fact that the stack is handled differently than the registers on mode switches seems a bit surprising, but makes sense.