41CL MMU Reset upon serial cable insert/remove

[Ángel Martin]

(02-26-2015 02:04 PM)rprosperi Wrote:  Now, every time I insert or remove the serial cable on the 41CL end (plugged-in already on the PC side) the MMU is disabled. Note the configuration is preserved so I need only re-enable the MMU to continue.

Have other 41CL users had this same experience?

It may be because you're plugging the cable to the CL with the other end already connected to the PC COM port?

If you first plug the CL end and then the PC end this should not occur.