Slope() appears broken.

Threaded Mode | Linear Mode

Slope() appears broken.

12-17-2014, 04:27 AM

Post: #7

mpowell@rogershsa.com Offline

Junior Member

Posts: 17
Joined: Dec 2014

RE: Slope() appears broken.

(12-17-2014 04:20 AM)Han Wrote:
(12-17-2014 03:46 AM)mpowell@rogershsa.com Wrote: Ok, On the Virtual HP Prime it shows a 10, but on the regular HP Prime calculator it shows a 0..

Did you make sure that you typed SLOPE in all caps?

Yes. I must of used x instead of X.

« Next Oldest | Next Newest »

Messages In This Thread

Slope() appears broken. - mpowell@rogershsa.com - 12-17-2014, 01:53 AM

RE: Slope() appears broken. - Han - 12-17-2014, 02:17 AM

RE: Slope() appears broken. - Marcel - 12-17-2014, 02:18 AM

RE: Slope() appears broken. - Marcel - 12-17-2014, 02:40 AM

RE: Slope() appears broken. - mpowell@rogershsa.com - 12-17-2014, 03:46 AM

RE: Slope() appears broken. - Han - 12-17-2014, 04:20 AM

RE: Slope() appears broken. - mpowell@rogershsa.com - 12-17-2014 04:27 AM

RE: Slope() appears broken. - Helge Gabert - 12-17-2014, 02:16 PM

RE: Slope() appears broken. - Tim Wessman - 12-17-2014, 02:57 PM

RE: Slope() appears broken. - Helge Gabert - 12-17-2014, 04:34 PM

User(s) browsing this thread: 1 Guest(s)