[FRAM71] Pre-Production Batch
|
06-09-2015, 05:03 PM
Post: #130
|
|||
|
|||
RE: [FRAM71] Pre-Production Batch
(06-09-2015 01:32 PM)Hans Brueggemann Wrote: TL; DR: FlashPro4 needs special programming cable with VJTAG support, otherwise will give error. Interesting. Are there any other differences between the HW104 modules, besides the programming header being pre-installed on the later batch? I didn't mention it before, but my cable is wired as follows: Code:
... and I get the following warning: Warning: programmer '73735' : Vpump has been selected on programmer AND an externally provided Vpump has also been detected. Using externally provided Vpump voltage source. The Microsemi datasheet states that the VPUMP provided by the programmer can supply one device and that VPUMP and VJTAG should be provided by separate supplies. Despite this, has connecting pins 6 and 7 on the FlashPro4 end of the cable been tried? Dave |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)