Simple program
|
02-21-2024, 06:27 PM
Post: #5
|
|||
|
|||
RE: Simple program
On the 35s, the INPUT command disables stack-lift. See page B-5 of the 35s user's manual. The 32s manual says it works the same. Are you sure the program works for you on a 32s?
You could get around the problem by adding ENTER before each INPUT command. That would put the value in the Y register also. In essence, you'd be pre-lifting the stack. Hope this helps, Dave |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Simple program - Flippy - 02-20-2024, 03:18 PM
RE: Simple program - rprosperi - 02-20-2024, 04:06 PM
RE: Simple program - David Hayden - 02-20-2024, 05:41 PM
RE: Simple program - Flippy - 02-20-2024, 08:31 PM
RE: Simple program - David Hayden - 02-21-2024 06:27 PM
|
User(s) browsing this thread: 1 Guest(s)