DM-15L Display
|
06-17-2022, 08:19 PM
(This post was last modified: 06-19-2022 02:20 AM by rprosperi.)
Post: #2
|
|||
|
|||
RE: DM-15L Display
While there are specific directions here (somewhere...), now that summer is upon us, you can also try leaving it, FACE DOWN, in direct sunlight for an hour or so, it may have the same curative effect as the heat from the oven. If you see a little bit of the blemish has disappeared, rinse and repeat, but I would not leave it out for multiple hours all at once.
Edit: Note that this advice applies only to Voyager family SwissMicros machines, and only for LCD blemishes that were present when you received the device when new. Do not use this technique for spots caused by damaged/leaking LCD. --Bob Prosperi |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
DM-15L Display - GerryS - 06-17-2022, 07:30 PM
RE: DM-15L Display - rprosperi - 06-17-2022 08:19 PM
RE: DM-15L Display - lrdheat - 06-18-2022, 07:48 PM
RE: DM-15L Display - rprosperi - 06-18-2022, 07:58 PM
RE: DM-15L Display - mfleming - 06-18-2022, 09:25 PM
RE: DM-15L Display - rprosperi - 06-19-2022, 02:19 AM
RE: DM-15L Display - lrdheat - 06-18-2022, 09:31 PM
RE: DM-15L Display - blackjetrock - 06-18-2022, 10:14 PM
RE: DM-15L Display - emece67 - 06-20-2022, 08:09 PM
RE: DM-15L Display - rprosperi - 06-20-2022, 08:38 PM
RE: DM-15L Display - GerryS - 07-02-2022, 08:05 PM
|
User(s) browsing this thread: 1 Guest(s)