newRPL keyboard overlay

[lmamakos]

Claudio, thanks for the feedback, and most of all, for all the wonderful work you've invested to create some wonderful software.

These are great suggestions, and I'll play around a bit to see what fits. I was also pondering printing an adhesive reference card/cheetsheet that could stick on the back of the calculator, in the area that's slightly recessed and has the serial number. And what makes sense to put there - perhaps the ON-hold actions which don't happen that frequently?

For the rear label, I think it would take more abuse and would need some sort of clear laminate covering over the printed vinyl I'm using. I'm printing with a laser printer right now, and don't really know how durable that's going to be on the key tops. If I can find some thin enough clear vinyl to laminate over it before cutting it, that might address that concern.

I also need to not get too clever as the alignment tolerances are probably only about within a mm or so.. I can't crowd the outline of the keys that get cut too closely because of that. I can see what a slippery slope this cutter thing is, just like my 3D printer :-)