HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / Controlling program exit

Post Reply 
Controlling program exit
11-18-2020, 09:41 PM
Post: #16
Han Offline
Senior Member
 		Posts: 1,882
Joined: Dec 2013
RE: Controlling program exit
When I ran your code (deleting the ... and changing -> to the right-arrow symbol), it works just fine. That is, it exited as soon as I hit the backspace key.

What happens when you change the detection to a different key? Does it exit properly? (This is to check if there is a hardware issue with the backspace key).

When you add DEBUG just before the UNTIL statement, what is the content of your 'input' variable?
Graph 3D | QPI | SolveSys
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Controlling program exit - cahlucas - 11-13-2020, 05:03 PM
RE: Controlling program exit - cahlucas - 11-13-2020, 10:16 PM
RE: Controlling program exit - Han - 11-13-2020, 10:44 PM
RE: Controlling program exit - cahlucas - 11-13-2020, 11:08 PM
RE: Controlling program exit - Jacob Wall - 11-14-2020, 04:31 PM
RE: Controlling program exit - cahlucas - 11-15-2020, 07:55 PM
RE: Controlling program exit - Jacob Wall - 11-15-2020, 10:58 PM
RE: Controlling program exit - cahlucas - 11-17-2020, 05:31 PM
RE: Controlling program exit - Jacob Wall - 11-17-2020, 09:08 PM
RE: Controlling program exit - cahlucas - 11-18-2020, 05:55 PM
RE: Controlling program exit - Han - 11-17-2020, 10:15 PM
RE: Controlling program exit - Han - 11-18-2020 09:41 PM
RE: Controlling program exit - cahlucas - 11-20-2020, 01:59 AM
RE: Controlling program exit - Han - 11-21-2020, 04:53 PM
RE: Controlling program exit - cahlucas - 11-21-2020, 11:54 PM
RE: Controlling program exit - Han - 11-30-2020, 01:57 AM
RE: Controlling program exit - cahlucas - 11-30-2020, 10:01 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication