Controlling program exit

[Jacob Wall]

I just drag & dropped the .hpprgm file over to the Programs folder of a connected G2 calculator and everything worked completely fine.

Are you on Windows or Mac?

Starting to sound like something else is at play here. My recommendation would be to:
- Create a backup of your calculator
- Format C (or factory reset) by
-- Hold simultaneously C F O keys on the keyboard
-- Insert paper clip in reset hole on the back
-- Keep holding C F O keys until DIAGNOSTIC screen pops up
-- 4. FLS Utility
-- 3. Format Disk C

If the problem goes away then something was corrupt with your calculator, if the same problem exists after reset then you can always restore your Backup and possibly look at what could be causing the problem on the CK side