Hp-41C card reader - dead
|
05-29-2022, 03:55 PM
Post: #118
|
|||
|
|||
RE: Hp-41C card reader - dead
the o-rings are the right ones, the coupler was made by Teenix. I have aligned the coupler and given it a go before attaching the motor to the frame. How did I do this? Well, I powered the motor and checked that the worm gear was turning without wobbling while the motor was turning. I will now, euphemism, try turning the pin slightly and insert a card, then repeat this operation until the pin has done a 360 degree turn.
Is there anybody in Europe that has the tools to veriify if the card reader does work or not? I could send it to somebody in Europe or send it to the USA - Australia - Mexico but it might be cheaper to buy a used one from ebay, I think. Very 'frustrated' Marco |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)