HP 9885M and Series 200/300 Computers
|
12-20-2019, 04:25 AM
(This post was last modified: 12-20-2019 04:40 AM by Paul Berger (Canada).)
Post: #2
|
|||
|
|||
RE: HP 9885M and Series 200/300 Computers
(12-19-2019 11:25 PM)Michael Fehlhammer Wrote: 9885 is not a typo in the headline - I am trying to operate an old single sided 8 inch floppy drive (mainly used along with 9825 computers) connected to a series 200/300 computer and BASIC 5 or BASIC 6 for workstations. I have not done it yet but I have thought about it. Page 1-3 of the manual for the 98622A GPIO lists the switch setting for the GPIO and it looks like the the cable would be a straight through cable with the appropriate connectors on each end. The simplest way to make a cable would be to get IDC connectors and crimp them onto a 50 conductor ribbon cable. I don't have a IDC connector on hand so I am working up an adapter for the usual cables I use on my GPIOs. You may want to post your questions about 9000s on the VintHPcom group on groups.io I believe you will reach a larger audience of HP 9000 user there than you will here. Paul. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HP 9885M and Series 200/300 Computers - Michael Fehlhammer - 12-19-2019, 11:25 PM
RE: HP 9885M and Series 200/300 Computers - Paul Berger (Canada) - 12-20-2019 04:25 AM
RE: HP 9885M and Series 200/300 Computers - Michael Fehlhammer - 12-20-2019, 12:57 PM
RE: HP 9885M and Series 200/300 Computers - Paul Berger (Canada) - 12-21-2019, 02:10 AM
|
User(s) browsing this thread: 1 Guest(s)