Post Reply 
HP-67 Charger Connector
06-30-2019, 04:27 PM
Post: #8
RE: HP-67 Charger Connector
(06-30-2019 07:06 AM)[kby] Wrote:  
(06-29-2019 10:31 AM)Robert VM Wrote:  The contacts in the "Molex" connectors used to connect power to hard disk drives (pre-SATA) fit nicely. They are somewhat long though.
Robert

EIther we're thinking of different plug sumewhere, or…?

The molex pins in the usual 4-pin power connector for a 3.5" disk drive are are much larger in diameter.-kby

I did manage to find an old hard drive power connector. I removed the Molex female pins from the connector. They fit perfectly in my connector (diameter) but are much too long. I will try to cut them short and just solder wires to what is left.

I also tried some 2mm bullet connectors they are very loose on the connector i will try modifying the model to fit.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP-67 Charger Connector - twoweims - 06-27-2019, 02:05 PM
RE: HP-67 Charger Connector - mfleming - 06-28-2019, 05:33 AM
RE: HP-67 Charger Connector - [kby] - 06-28-2019, 06:46 AM
RE: HP-67 Charger Connector - Robert VM - 06-29-2019, 10:31 AM
RE: HP-67 Charger Connector - [kby] - 06-30-2019, 07:06 AM
RE: HP-67 Charger Connector - twoweims - 06-30-2019 04:27 PM
RE: HP-67 Charger Connector - twoweims - 06-29-2019, 02:37 PM
RE: HP-67 Charger Connector - mfleming - 06-30-2019, 02:52 PM
RE: HP-67 Charger Connector - twoweims - 06-30-2019, 04:32 PM



User(s) browsing this thread: 1 Guest(s)