WTB : HP67 card reader wire connector

[teenix]

(03-28-2019 12:31 AM)Johnboy Wrote:  Hi All,

I'm not sure how to describe this part that I need, but on the later HP67 card readers, the motor and power wires are not soldered, but use a push-in connector.

I need one of those connectors, as I managed to break the power wire such that there's a small piece of wire stick in the connector, and now I can seem to push any more wire into it.

I'm happy to take a whole dead 67 card reader board if it has at least one of those connectors.

Any help appreciated.

Thanks
John

I think these are used to provide strain relief for the wires at the termination point.

You could solder the wire directly to the pin.

cheers

Tony