pyILPER 1.8.0 final release
|
02-20-2019, 06:56 AM
(This post was last modified: 02-20-2019 06:59 AM by jsi.)
Post: #7
|
|||
|
|||
RE: pyILPER 1.8.0 final release
Hello Sylvain,
(02-20-2019 12:43 AM)Sylvain Cote Wrote: It is working, but the terminal polling by the HP-75 make this so inefficient, it's scary. The KEYBOARD IS implementation of the HP-71 is obviously much more efficient than the HP-75 version. I don't own such a device and had no "user experience" so far with a HP-75 and the terminal emulation. But iit is fun if you use pyILPER with the EMU75 emulator of J-F Garnier which can run at much higher speed than the original device. This works, because the HP-75 KEYBOARD is implementation does not use service requests. Regards Joachim |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
pyILPER 1.8.0 final release - jsi - 02-14-2019, 07:48 PM
RE: pyILPER 1.8.0 final release - rprosperi - 02-15-2019, 01:30 AM
RE: pyILPER 1.8.0 final release - Erwin - 02-15-2019, 05:33 AM
RE: pyILPER 1.8.0 final release - jsi - 02-15-2019, 11:09 AM
RE: pyILPER 1.8.0 final release - Erwin - 02-16-2019, 07:02 AM
RE: pyILPER 1.8.0 final release - Sylvain Cote - 02-20-2019, 12:43 AM
RE: pyILPER 1.8.0 final release - jsi - 02-20-2019 06:56 AM
RE: pyILPER 1.8.0 final release - Sylvain Cote - 02-21-2019, 03:58 AM
|
User(s) browsing this thread: 1 Guest(s)