HP Forums / HP Calculators (and very old HP Computers) / General Forum v / how to get "out of box" state

Post Reply 
how to get "out of box" state
10-02-2018, 09:13 AM (This post was last modified: 10-02-2018 09:23 AM by BartDB.)
Post: #5
BartDB Offline
Member
 		Posts: 162
Joined: Feb 2015
RE: how to get "out of box" state
Hi,

After RESET, in port "2: FLASH" delete everything EXCEPT L226, L227 & L229 - these form the Equation Library and Periodic Table that is normally factory installed.

If you do accidentally delete them, I have attached them here. Just re-install them (use an SD card to copy back to port 2).


Regards.


Attached File(s)
.zip  EqnPerLib.zip (Size: 54.6 KB / Downloads: 8)

Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
how to get "out of box" state - samo50g - 10-01-2018, 04:55 PM
RE: how to get "out of box" state - BartDB - 10-02-2018, 09:27 AM
RE: how to get "out of box" state - DavidM - 10-02-2018, 02:28 PM
RE: how to get "out of box" state - BartDB - 10-02-2018 09:13 AM
RE: how to get "out of box" state - BartDB - 10-02-2018, 10:14 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication