Post Reply 
82240B printhead fried itself in a puff of smoke
03-18-2020, 01:28 PM (This post was last modified: 03-18-2020 01:42 PM by twoweims.)
Post: #32
RE: 82240B printhead fried itself in a puff of smoke
(03-18-2020 10:40 AM)tcab Wrote:  Thanks ? very useful information.

Very unusual connection technique on those wired - each wires with slight cuts in the plastic sheath and inserted physically into a slot. Not soldered at all - not sure how to reproduce the cuts in the plastic sheath of the wire. Probably will simply strip the wire bare and insert it in!

I wasn't very clear. The connector that I have circled just unplugs from the main board.
There is no need to re-terminate the wires on that end. You need to reconnect them to the new print head. You will understand when you get it apart. I should have taken more pictures during the process.

This is where the wires need to be soldered to the new print head:

   
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: 82240B printhead fried itself in a puff of smoke - twoweims - 03-18-2020 01:28 PM



User(s) browsing this thread: 1 Guest(s)