Post Reply 
HP 50g: PUT Bug?
03-14-2014, 07:21 PM
Post: #4
RE: HP 50g: PUT Bug?
(03-14-2014 04:08 PM)JimS Wrote:  Hi,
It is not a bug.
After you do the PUT command the stack will show [5 0].
You have to store this new vector into the old one with STO XX.

Hope this helps.

Thank you Jim,

It was very important for me your advise. I already had stopped all programing tries because of that PUT.
Yes, the STO command must be issued too. There is the Algebraic Mode but it is still a "Stack" oriented Calc.

I had tried that STO too, I still had it stored as a Program for the testing. I can not believe that I did not see it.
Maybe I had switched to the stack mode before I used the program.
Thanks again.
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
HP 50g: PUT Bug? - Alvaro - 03-09-2014, 06:35 PM
RE: HP 50g: PUT Bug? - RMollov - 03-10-2014, 03:51 AM
RE: HP 50g: PUT Bug? - JimS - 03-14-2014, 04:08 PM
RE: HP 50g: PUT Bug? - Alvaro - 03-14-2014 07:21 PM

User(s) browsing this thread: 1 Guest(s)