Post Reply 
Reboot Problem
02-03-2017, 02:03 PM (This post was last modified: 02-03-2017 02:04 PM by toml_12953.)
Post: #1
Reboot Problem
I have three HP Primes - one HW A, one HW C with old keyboard, one HW C with new keyboard. I have the 10637 firmware installed on each. Whenever I try to create a new program on any of them, the calculator reboots. After the reboot, the program stub (just the EXPORT, a BEGIN and an END) is there. When I try to delete a program, the same thing happens. The calculator reboots and when it finishes booting, the program is gone. I tried reflashing the firmware on all three calcs but no change. I really don't think it's a hardware problem since it happens exactly the same way on three different machines. If it was a software problem, other people would be reporting it, wouldn't they? I'm stumped!

Tom L

Tom L
...other than that, Mrs. Lincoln, what did you think of the play?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Reboot Problem - toml_12953 - 02-03-2017 02:03 PM
RE: Reboot Problem - Han - 02-03-2017, 02:27 PM
RE: Reboot Problem - toml_12953 - 02-03-2017, 04:19 PM
RE: Reboot Problem - Tim Wessman - 02-03-2017, 03:33 PM



User(s) browsing this thread: 1 Guest(s)