How do I load a LIF into EMU71/WIn?

[rprosperi]

(12-29-2017 05:18 PM)mstram Wrote:  I just tried all your steps in your post re: the Emu71
This on Win 7 / Emu71 1.09

On entering RESTORE IO, I get "ERR: Stmt not found"

Mike

emu71.ini :

Code:


; emu71.ini        Emu71 initialisation file
;
[MODULES]
; 10 softwired modules max., plus 1 hardwired module
; main RAM in port 0 only
; port(1-5) type(ROM,RAM,HRD) size(Ko) file
0 RAM 32 ram00.bin
1 ROM 16 hpilrom.bin
5 RAM 32 iram50.bin
;
[DEVICES]
DISPLAY
HDRIVE1
HDRIVE2
DOSLINK
LPRTER1

It appears you are mixing EMU71/DOS (JF Garnier) and EMU71/Win (Christoph Gisselink).

The thread above refers (primarily) to the Windows version (EMU71/Win) where the HP-IL module is optional, thus RESTORE IO is needed to initialize the loop if you are using it.

EMU71/DOS (which it seems you might be using from the .ini file reference, which only applies to the Win version) has an HP-IL module "built-in" and therefore RESTORE IO is not needed.

But you specifically mention Using EMU71/Win 1.09...

The error message you get implies the HP-IL Module is not installed, or not installed properly (the RESTORE IO command comes from this module, and the command is not recognized).

Have you installed (via Edit... Port configuration) an HP-IL module and configured it to communicate with ILPer via TCP/IP ? The EMU manual explains how to configure the HP-IL module and the docs that come with the latest ILPer client explain the TCP/IP configuration.

Give all that a try and update this thread with questions or issues.