Post Reply 
Apollo Software
08-23-2016, 09:17 AM
Post: #10
RE: Apollo Software
(08-23-2016 01:31 AM)rprosperi Wrote:  That is all correct, I'm pretty sure the AGC was in the ascent stage. But bottom line, his code really is still on the moon, though the hardware around it may be a bit (pun intended) worse for the wear.

Thanks Bob. It would be interesting if a future mission to the moon would bring back some of the artifacts from the Apollo missions that were left on the moon, especially to see how the daily lunar temperature extremes affected them. There must be some great Hasselblad cameras up there!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Apollo Software - hp41cx - 08-18-2016, 07:14 PM
RE: Apollo Software - Don Shepherd - 08-19-2016, 09:02 PM
RE: Apollo Software - Bill (Smithville NJ) - 08-20-2016, 11:30 AM
RE: Apollo Software - Karl-Ludwig Butte - 08-21-2016, 10:42 AM
RE: Apollo Software - Don Shepherd - 08-21-2016, 05:18 PM
RE: Apollo Software - Maximilian Hohmann - 08-22-2016, 10:47 AM
RE: Apollo Software - Don Shepherd - 08-22-2016, 11:57 PM
RE: Apollo Software - rprosperi - 08-23-2016, 01:31 AM
RE: Apollo Software - Don Shepherd - 08-23-2016 09:17 AM
RE: Apollo Software - rprosperi - 08-23-2016, 01:28 PM
RE: Apollo Software - Jeff O. - 08-24-2016, 01:22 PM
RE: Apollo Software - rprosperi - 08-24-2016, 02:04 PM
RE: Apollo Software - Jeff O. - 08-25-2016, 11:40 AM
RE: Apollo Software - BobVA - 08-24-2016, 02:54 AM
RE: Apollo Software - Massimo Gnerucci - 08-21-2016, 01:53 PM
RE: Apollo Software - Ron Ross - 08-23-2016, 01:31 PM
RE: Apollo Software - Don Shepherd - 08-23-2016, 02:02 PM
RE: Apollo Software - rprosperi - 08-23-2016, 02:43 PM
RE: Apollo Software - twdeckard - 08-24-2016, 03:06 AM
RE: Apollo Software - Jeff O. - 08-24-2016, 01:28 PM
RE: Apollo Software - Karl-Ludwig Butte - 08-25-2016, 12:03 PM
RE: Apollo Software - 4ster - 08-25-2016, 02:58 PM
RE: Apollo Software - Accutron - 08-25-2016, 10:33 PM
RE: Apollo Software - hp41cx - 08-28-2016, 12:55 AM



User(s) browsing this thread: 1 Guest(s)