HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / Firmware 5447: Iterate() bug or feature?

Post Reply 
Firmware 5447: Iterate() bug or feature?
02-13-2014, 08:54 PM (This post was last modified: 02-13-2014 08:56 PM by Han.)
Post: #10
Han Offline
Senior Member
 		Posts: 1,882
Joined: Dec 2013
RE: Firmware 5447: Iterate() bug or feature?
I'm testing on the actual hardware and I am able to run the command just fine (in CAS view) using 10001 as the number of iterations (much larger than 1001).

ITERATE(z^2+.37-.14*i,z,0,10001) returns .360559337343-.737717172019*i

However, in the Home view, I get Error: Invalid input for more than 1000 iterations. So it looks like a this and probably more commands need to be updated, still.
Graph 3D | QPI | SolveSys
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Firmware 5447: Iterate() bug or feature? - Han - 02-13-2014 08:54 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication