Pre Release HP01 Running

[fhub]

(07-17-2016 10:44 AM)teenix Wrote:  1) If you look in the menu you can see an option [Fine tune timer] This will adjust the timer for the processor execution loop and therefore the time updates. A bit like using the crystal trimmer on the watch circuit board. It will never be perfect, but neither was the actual watch. The time will always drift slightly. It will sync to the PC time on start up.

Well, of course I've seen this option, but without showing a scale with any values such a slider is almost useless - how many trials would be needed to adjust the speed to be (almost) exact?
And moreover, is this fine tune setting stored in the cce33.ini or hp01.ini?
If not then you would have to set it again and again ...

Quote:The 'a' key sets the time or alarm to [am] if it is in the default 12 hour mode of operation.

Ok, the manual of the official release describes it in the same way, but nevertheless it sounds a bit strange to me: why waste one key (or even two keys in the prerelease version) for am/pm, when you can simply enter the time in both formats (e.g. 4:15 or 16:15)?
So I still don't really understand the benefit of these keys. And BTW, when the stopwatch is running, both keys ("a" and "p") seem to have any other function, but I haven't yet found out what it is - it looks like some kind of 'pause', but showing a different display value. Very mysterious ...

Franz