pyILPER Version 1.3.3 released
|
04-14-2016, 03:32 PM
Post: #22
|
|||
|
|||
RE: pyILPER Version 1.3.3 released
(04-14-2016 04:58 AM)jsi Wrote: Dave, did you check the "Enable IDY frames option" in the pyILPER configuration? Hi Joachim, It seems that I only acquired the PIL-Box 1.6 firmware, but had not yet installed it. All works fine now. I left the top half of the PIL-Box case off while verifying proper operation and I like the visual feedback the LED gives. Perhaps I'll further modify the case to bring out the LED, transplant the board into a clear acrylic case, or 3D print something custom. Thanks, Dave |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)