pyILPER Version 1.3.3 released

[jsi]

Hello Robert,

you can simply overwrite the com port name in the list box and enter an arbitrary com port number.

pyILPER requires only firmware revision 1.6 for the virtual keyboard of the terminal tab.
All other devices (including the display emulation of the terminal tab) should work with
previous firmware revisions. Please also check the baud rate in the configuration menu.

If the status line of pyILPER shows "connected to PILBOX" then serial communication should
be ok. Please mind to enable the virtual HP-IL devices with the check box at the bottom of each
tab. Then do a "RESTORE IO" on the HP-71. Now the virtual devices should be available to
the loop.
You may check the virtual device status in the Utilities menu an look if the virtual devices got
an HP-IL address.

Regards
Joachim