Post Reply 
Calculate 200^300 with SOLVE
03-02-2016, 06:09 PM
Post: #12
RE: Calculate 200^300 with SOLVE
(03-02-2016 03:29 AM)Gerson W. Barbosa Wrote:  P.S.: I'd gotten 9.99999999999E499. I only didn't get an overflow error because of flag -21 setting. Upon checking the CAS MODES screen I noticed Numeric had been checked. D'oh, just unchecking it might've been easier!

The different behaviors based on flag and CAS configurations is both a blessing and a curse. It's nice to be able to set or clear a flag to make wholesale changes in how things are processed, but the sheer quantity of them makes troubleshooting and comparing experiences with other users prone to puzzling inconsistencies sometimes. Perhaps I'll set a signature for my account here that says something along the lines of "...this is how it works on my particular calculator with my particular configuration. Your experiences may vary drastically from the above. Smile "

Like you, I also tend to use the emulator with Debug4x when trying things out before loading up my 50g. I'm reluctant to say how often I've been caught by the fact that ZINTs get converted automatically to REALs if the emulated calculator is in approximate mode when the UserRPL program is transferred to it by Debug4x. Subsequent mode changes don't matter at that point. The program object was compiled by the calculator with REALs, so the damage has already been done. Knowing about the issue and actually remembering to make the mode change before pressing "F9" are two different things, though.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Calculate 200^300 with SOLVE - tomisan - 02-28-2016, 12:01 PM
RE: Calculate 200^300 with SOLVE - Tugdual - 03-01-2016, 02:57 AM
RE: Calculate 200^300 with SOLVE - DavidM - 03-02-2016 06:09 PM
RE: Calculate 200^300 with SOLVE - Tugdual - 03-01-2016, 08:49 PM
RE: Calculate 200^300 with SOLVE - Arno K - 03-01-2016, 09:18 PM
RE: Calculate 200^300 with SOLVE - Tugdual - 03-01-2016, 09:24 PM



User(s) browsing this thread: 1 Guest(s)