HP Forums / HP Calculators (and very old HP Computers) / General Forum v / Soldering Station/Iron recommendation....

Post Reply 
Soldering Station/Iron recommendation....
07-11-2015, 09:46 PM
Post: #4
Hans Brueggemann Offline
Member
 		Posts: 242
Joined: Dec 2013
RE: Soldering Gun recommendation....
basically concurring with garth. also, look out for a high-ohmic protective earth connection on the soldering station where you can attach your ESD mat (and your ESD wrist wrap) to. a "soldering gun" for that matter is a definitive no-no on vintage CMOS electronics (and on all electronics, to be honest). buying a $30 soldering iron to fry a $150 vintage beauty is not going to save you anything.

hans
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Soldering Gun recommendation.... - Hans Brueggemann - 07-11-2015 09:46 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication