[71B, FRAM71] Using a USB GPIB interface to load files on a 71B
|
05-17-2015, 12:15 AM
Post: #3
|
|||
|
|||
RE: [71B, FRAM71] Using a USB GPIB interface to load files on a 71B
(05-16-2015 11:51 PM)Dave Frederickson Wrote: When copying ROM images into FRAM71, the technique is to FREEPORT a module, determine it's address using MEMBUF, then POKE the ROM data into the IRAM. This avoids clobbering main memory. Finally, the IRAM is reconfigured to ROM. I tried that, but for some reason didn't get it to work correctly. However I was also in the middle of development of the utility, so could have had some other problem. :-( |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[71B, FRAM71] Using a USB GPIB interface to load files on a 71B - cruff - 05-16-2015, 11:09 PM
RE: [71B, FRAM71] Using a USB GPIB interface to load files on a 71B - Dave Frederickson - 05-16-2015, 11:51 PM
RE: [71B, FRAM71] Using a USB GPIB interface to load files on a 71B - cruff - 05-17-2015 12:15 AM
RE: [71B, FRAM71] Using a USB GPIB interface to load files on a 71B - Dave Frederickson - 05-17-2015, 12:28 AM
RE: [71B, FRAM71] Using a USB GPIB interface to load files on a 71B - Dave Frederickson - 05-22-2015, 09:23 PM
RE: [71B, FRAM71] Using a USB GPIB interface to load files on a 71B - cruff - 05-23-2015, 12:25 AM
|
User(s) browsing this thread: 1 Guest(s)