Post Reply 
HP30B retunrning to "default values"
05-07-2015, 03:00 PM
Post: #5
RE: HP30B retunrning to "default values"
(05-07-2015 02:44 PM)Geoff Quickfall Wrote:  Also the battery hatch design is sadly lacking. A. Good knock or rap on the calc will temporarily disconnect the power supply causing the default. The battery then returns to position and the circuit is complete leaving you with a functional but 'defaulted' condition.

This happened to me with the 34s conversions when it was in my flight bag which gets tossed around at airport security. Fixed it by folding some paper to fit between the battery and the rear sliding case which adds more pressure holding the battery in place during these transient jolts.


Good point, Although I don't think it is my case, as I've seen the reset several times in the last month, and I don't use to drop or knock it so often (ar least I try not to).
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: HP30B retunrning to "default values" - ElectroDuende - 05-07-2015 03:00 PM

User(s) browsing this thread: 1 Guest(s)