Post Reply 
HP-41C service module question
09-06-2021, 12:13 PM
Post: #10
RE: HP-41C service module question
Hi Diego,

I received a memory module that was open and I assume it doesn't work.

How can I make this module an I/O test module?

What type of glue do you recommend to seal it again?

Thanks

(10-23-2014 02:17 AM)Diego Diaz Wrote:  Hi,

I just wired a second 82106A PCB inside a standard memory module, but without B3 & B4 lines.

So when the module is plugged into port 2, the 'original module' takes its address from the port wiring; while the added PCB memory is allocated as if it was plugged into port 1; where the Service module is installed.

As you can see, no rocket science whatsoever... ;-)

All the best.

Diego.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: HP-41C service module question - dmh - 09-06-2021 12:13 PM



User(s) browsing this thread: 1 Guest(s)