HP 41 screw post repair
|
03-10-2024, 01:50 PM
Post: #8
|
|||
|
|||
RE: HP 41 screw post repair
Yep. I thought about the M2 heat inserts too. But the outer diameter 3 mm put the idea off. There would be too little meat left in the posts.
You are right it can be slimmed with lathe. I do not have one. But, maybe if I put a screw in the brass insert to have something to grab a drill chuck on and then use a file to slim the brass down..... Thanks everyone! Karel |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HP 41 screw post repair - Karel - 03-06-2024, 02:44 PM
RE: HP 41 screw post repair - John Garza (3665) - 03-06-2024, 09:45 PM
RE: HP 41 screw post repair - rprosperi - 03-06-2024, 10:10 PM
RE: HP 41 screw post repair - Karel - 03-06-2024, 10:29 PM
RE: HP 41 screw post repair - rprosperi - 03-07-2024, 02:31 AM
RE: HP 41 screw post repair - aurelio - 03-08-2024, 08:04 AM
RE: HP 41 screw post repair - Martin Hepperle - 03-08-2024, 02:09 PM
RE: HP 41 screw post repair - Karel - 03-10-2024 01:50 PM
|
User(s) browsing this thread: 1 Guest(s)