Modified HP-71B MultiMOD Issue
|
02-24-2024, 03:38 AM
Post: #8
|
|||
|
|||
RE: Modified HP-71B MultiMOD Issue
(02-24-2024 02:03 AM)Sylvain Cote Wrote: You are correct, if you try to install both module at the same time, both module will map itself to the same address (0xE0000) resulting in a bus lookup. A MultiMod owner reported recently that a stock MultiMod and a Forth module in the same machine caused a lockup. He reported it as an error because he had disabled the MultiMod with a poke zero. Hey, how was I supposed to know that was a use case I should handle? [Cue the Marx Brothers clip about "Doctor, doctor, it hurts when I do this" ...] ~Mark NB. Mike will get refund if no fix found. Remember kids, "In a democracy, you get the government you deserve." |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)