Hp 67 card reader axle pin seated fully.?

[jftman]

(11-23-2023 10:11 PM)teenix Wrote:  It looks about right, it normally sticks out about a millimeter.

There is a picture of one in situ from a HP-67 on page 39 of my Classic Notes PDF file.

If you are unsure, remove the pin and place it across the top of the housing and you should see the same result when the inner edge of the cam end is in line with the inner plastic wall where it normally passes through.

cheers

Tony

ThankYou. I tried looking on the frame for evidence that the pin left an imprint as in being butted against but wasn’t really able to tell.

I had it all together and found out it doesn’t turn on.
Purchased as ‘untested’.
I posted a fresh thread just now.
Regarding Slider Switches and Trace Damage- HELPPPPP,!