Any hp prime debugger tutorials/docs out there?

[nickapos]

(08-04-2023 11:10 PM)BruceH Wrote:  

(08-04-2023 01:09 PM)nickapos Wrote:  ...but I guess I was expecting to see the values of the existing variables on the second part of the display automatically appear.

This is an annoyance but there may be too many variables and then you end up scrolling for ages to find the one you're interested in.

A useful improvement would be to allow the variables of interest to be specified in the debug() call, so debug(i,j,B) would start the debugger with the current values of i, j and B shown in the lower part of the display.

Yeah good points. I agree. This is not covered in the manual at all so there is space for improvement there as well.